IBM 3745 Series, Installation And Maintenance Manual

Page: 164 / 270

After Token-Ring Adapter Card Exchange
You are here after Token-Ring adapter card exchange.
1. Insert the Token-Ring Adapter Card Configuration diskette (PN 10K8634) in
the service processor.
2. Power ON the service processor and the attached display.
3. Wait until the following window is displayed:
‡ —
PC DOS 7.0 Startup Menu
1- IBM Token-Ring PCI Adapter Configuration using LANAIDC
2- IBM Token-Ring Adapter Extended Diagnostics for 4/16 Mbps
3- IBM Token-Ring Adapter Extended Diagnostics for 100 Mbps
Enter a choice: 1 Time remaining: xx
Hit any key to continue with LANIDC from diskette or remove diskette
and reboot system normally
ˆ ˜
4. Press a key on the keyboard. The following lines are added at the previous
screen.
‡ —
Enter LANAID parameters - reboot your machine when done
Examples: /View
/Help
LANAIDC >
ˆ ˜
5. Enter /VIEW
6. The following screen is displayed:
‡ —
Current Adapter Setting
Adapter Number: 1
Adapter MAC Address: xx xx xx xx xx xx
Microcode Level
yyyyyy zzzzzz
Card State: Enabled
I/O Address: 7400
Interrupt: 10
Latency Timer: 48
Remote IPL: Disabled*
Expansion ROM: Enabled* (Note)
* changes to RIPL and EXPROM will not be reflected until reboot
LANAIDC>
ˆ ˜
Note: Use the following command to change the value according to the
previous screen:
¹
/EXPROM=Y
7. Using the Esc to leave the configuration.
8. Remove the diskette.
9. Power OFF the service processor
10. Power ON the service processor
11. Go to Chapter 6, “CE Leaving Procedure” on page 6-1.
5-16
3745-XXA 5-16 3746-9X0: 6563 SPIM