IBM 3745 Series, Installation And Maintenance Manual

Page: 41 / 270

Go To
If you have installed:
¹
All the units in the controller expansion, go to Step 19 on page 1-17
¹
The keyboard and display are installed on a table, go to Step 20 on
page 1-17.
¹
All the units on a table, go to Step 22 on page 1-18 .
Warning
The ac outlet distribution box is connected to a 220V power source, all the
units must be set to support this voltage.
.
19. ____ Route and connect the power cords (PN 58G5783) from the display and
service processor unit to the ac outlet distribution box as shown in Figure 1-12.
Secure these cables using tie clamps along the frame, then go to step 21.
Display
Service Processor
Customer Receptacle
Figure 1-12. Power Cords Connection
20. ____ Connect the display power cable
.M/
to the ac outlet distribution box
(refer to Figure 1-11 on page 1-16). Secure all the cables using tie clamps
along the frame.
21. ____ If it is not already plugged, connect the main power cord
.P/
coming from
the ac outlet distribution box to the customer receptacle (refer to Figure 1-13
on page 1-18).
Chapter 1. Installing and Setting Up Your Service Processor
1-17