IBM 3745 Series, Installation And Maintenance Manual

Page: 136 / 270

Diagnostic Error Code FRU/Action
006-196-XXX
Diskette interface test halt, error threshold
exceeded 1. Depress F3 to review the log file.
See
“Viewing the Test Log” on
page 4-8.
2. Re-start the test to reset the log file.
006-197-XXX
Diskette interface test warning 1. Make sure component that is called
out is enabled and/or connected
2. Re-run test
3. Component that is called out in
warning statement
4. Component under test
006-198-XXX
Diskette interface test aborted 1. If a component is called out, make
sure it is enabled and/or connected
2. Flash the system and re-test
3. Go to “Undetermined Problems” on
page 3-23
006-199-XXX
Diskette interface test failed, cause
unknown 1. Go to “Undetermined Problems” on
page 3-23.
2. Flash the system and re-test
3. Replace component under function
test.
006-25X-XXX
Diskette interface Error 1. Diskette drive Cable
2. Diskette drive
3. System board
011-000-XXX
Serial port Interface Test Passed 1. No action
011-001-XXX
Serial port Presence 1. Remove external serial device, if
present
2. Run setup, enable port
3. System board
011-002-XXX
011-003-XXX
Serial port Timeout/Parity error 1. System board
011-013-XXX
011-014-XXX
Serial port Control Signal/Loopback test
failure 1. System board
011-015-XXX
Serial port External Loopback failure 1. Wrap plug
2. System board
011-027-XXX
Serial port Configuration/Setup error 1. Run Setup, enable port
2. Flash the system
3. System board
011-03X-XXX
011-04X-XXX
Serial port failure 1. System board
011-195-XXX
Serial port Test aborted by user 1. Information
2. Re-start the test, if need to
4-14
3745-XXA 4-14 3746-9X0: 6563 SPIM