Hyundai HX145 LCR, Manual

Page: 642 / 702

8-170
TRAVEL REDUCTION GEAR ASSEMBLY
Even though assembly is accomplished by
reversing disassembly steps, be careful of the
following.
Repair the damaged part when disassemblying
and prepare parts for exchange in advance.
All parts should be cleaned with cleaner, dried
with compressed air.
Sliding surface, O-ring, bearing and oil seal
should be lubricated with clean hydraulic oil,
prior to final assembly.
Replacement of O-ring and oil seal with new
parts is generally recommended.
Use a torque wrench to make sure that
assembly fasteners are tightened to specified
values.
When assembling bolt, spread loctite.
Η
Θ
Ι
Κ
Λ
Μ
4.
ö
Put carrier No.1 (13) on the jig, and shrink-fi t inner
race No.1 (16) to carrier pin.(3 places)
Do not tilt inner race to one side.
Match inner race and end of carrier pin.
Assemble needle bearing No.1 (15).(3 pcs)
1)
ö
ö
2)
125LCR8TM90
125LCR8TM91