HP StorageWorks 12000, User Manual

Page: 172 / 266

• Edit the Fibre Channel host port settings
• Enable oversubscription and view oversubscription settings
• View LUN mapping
• Create, view, and destroy virtual libraries, tape drives, or cartridges
• Add, view, or remove barcode templates
Table 6 CLI configuration commands
Usage
1
Command
Add a node to the VLS. See
getNodeNames
.
addNode
Discovers any new arrays added to the VLS.
discoverArray
Changes the default FC host port connection settings. Where the options are:
-a <n>
- ID number of node to modify (0, ...) (optional)
-i <n>
- FC index (0, 1, ...) (required)
-l <n>
- If attached in arbitrated loop mode, specifies a hard ALPA value between
0 and 125. A value of -1 specifies a dynamically assigned ALPA. If not attached
to an arbitrated loop, this parameter is ignored (required)
-r <n>
- Port number of the FC port to modify (required)
-s <n>
- Preferred speed (0-Auto, 1-One GB, 2-Two GB, 4-Four GB, or 10-Ten
GB) (required)
-t <n>
- Preferred topology (0-Auto, 1-Point to Point, 2-Loop, 3-Fabric, or 4-Public
Loop) (required)
-h
- Displays command usage information (optional)
updateFC
Enables or disables oversubscription and specifies the percent storage remaining
for notification. Where the options are:
-e <n>
- Enable/disable oversubscription (0-Disabled or 1-Enabled) (required)
-p <n>
- Percentage of capacity remaining for alert notification (required)
-h
- Displays command usage information (optional)
setOverSubscription
Returns whether the oversubscription feature is enabled or disabled and the capa-
city remaining percentage for notification alert. Oversubscription is enabled when
enabled = 0
. Oversubscription is disabled when
enabled = 1
.
getOverSubscription
Returns a list of available library emulation types. Displays each library emulation's
name, type, product, revision, and vendor information. Where the options are:
-l
- List only licensed types (optional)
-h
- Displays command usage information (optional)
getLibTypes
CLI Command Set 172