HP StorageWorks 12000, User Manual, Page: 170 / 266

Description Command
Closes the connection to the VLS.
close
Displays the fully qualified name of the VLS and its IP address.
getHost
Connects to a host. Where
<-tag>
can be:
-a<s>
- Host name (localhost is default) (optional)
-p<s>
- Password (optional)
-u<s>
- userid (optional)
connect
Output Commands
Use the CLI commands in CLI output commands to control the output and display help information for
the CLI commands.
Table 4 CLI output commands
Description Command
Displays the stack trace after an exception has occurred.
trace
Toggles verbose output on and off. When on, all messages are output to the screen.
verbose
Indicates current CLI version. If verbose is on, the module revisions display also.
version
Displays CLI command usage information. Where
<-tag>
can be:
-c<command>
- Provides help information for the specified CLI command.
-all
- Lists all CLI commands and their help information.
help
Enables VLS logging. Where the options are:
-d<n>
- Debug level (1 to 9) (optional)
-h
- Displays command usage information (optional)
enableVlsLog
Disables VLS logging. Where the options are:
-d<n>
- Debug level (1 to 1) (optional)
-h
- Displays command usage information (optional)
disableVlsLog
VLS Commands
This section describes the VLS commands in the VLS CLI command set.
Network Settings Configuration Commands
Use the CLI commands in CLI network settings configuration commands to configure the VLS network
settings via a serial session. See “ Opening a Serial Session ” on page 109.
Changing the network configuration parameters modifies four system files:
/etc/hosts
/etc/sysconfig/network
CLI Command Set 170