HP StorageWorks 1/8, User'S And Service Manual, Page: 73 / 204

IMPORTANT:
Once you reset the administrator password to null, you will not be able to access the administrator
functions in the RMI until you set an administrator password through the OCP. To
change the
administrator password, use “ Configuration: Password page ” on page 70.
The saved configuration database will make it easier to recover the device configuration if you need
to replace the chassis. This feature is also useful when installing multiple devices. Either save the
configuration before configuring the network or ensure that only one device with the same network
configuration is on the network at a time until they have unique network identities.
NOTE:
You can save the device configuration to a USB flash drive from the OCP. For the , see “ Saving and
restoring the Autoloader configuration (Configuration > Save/Restore Configuration) ” on page 96.
Figure 46 Configuration: Save/Restore page
.
The restored factory default settings are:
• SCSI address: 4
• Drive power: drive powered on
• Active slots: maximum possible
• Autoloader mode: Automatic
• Loop: No
• Event log levels and filter: continuous trace and all levels and filters active (for HP Service use only)
• Barcode reader label length: 8
• Barcode reader alignment: Left
• Error recovery: On
• Mailslot configuration: mailslot disabled
• Auto clean: disabled
• SNMP: disabled, but saved addresses do not change
• E-mail notification: disabled, but configurations retained
HP StorageWorks 1/8 G2 Tape Autoloader User and service guide 73