HP StorageWorks 1/8, User'S And Service Manual, Page: 37 / 204

3. From the front of the device, secure the front bezel to the rack using a #2 Phillips screw driver
placed through the small holes in the mounting bracket to tighten the captive screws on each side
of the device.
Figure 14 Securing the Autoloader to the rack
.
Installing the Tabletop Conversion Kit
If you do not have the optional Tabletop Conversion Kit, skip this step and continue with Connecting
the SCSI cable (parallel SCSI devices only) . The Rack to Tabletop Conversion Kit supports the edges
of the Tape Autoloader and is capable of holding 15 kg (33 lb).
To install the cover:
1. Place the cover on a flat, level surface behind the device.
2. Slide the device into the cover until the front panel of the device is aligned with the cover (see
Figure 15 ).
Figure 15 Installing the tabletop conversion cover
.
3. Tighten the captive screws on the front panel until the cover is secure.
Changing the SCSI address (parallel SCSI drives only)
If you have multiple parallel SCSI devices on the SCSI bus and another device is already using SCSI
ID 4, you must change the SCSI ID of the Autoloader.
To change the SCSI ID:
HP StorageWorks 1/8 G2 Tape Autoloader User and service guide 37