HP StorageWorks 1/8, User'S And Service Manual, Page: 34 / 204

1. Verify that there are no tape cartridges in the Autoloader.
IMPORTANT:
The Autoloader may be damaged if it is turned over with tape cartridges in the magazines
or robot. If the Autoloader has been used before, use the manual magazine release to
remove the cartridges from the magazines (see “
Using the manual release ” on page 162.
2. With another person, gently turn the Autoloader over and set it on its back.
3. Locate the six inscribed foot location lines on the bottom of the Autoloader.
4. If the Autoloader is not new, clean the foot locations with a damp paper towel.
5. Peel the backing paper off each foot and apply it within a set of foot location lines (see Figure
9 on page 34).
6. With another person, gently turn the Autoloader over and set it on its feet.
Figure 9 Attaching the feet to the bottom of the Autoloader
.
Removing the shipping lock
The shipping lock prevents the robotic transport mechanism from moving during shipment. You must
remove the shipping lock before powering on the device. The shipping lock is held in place with a
piece of tape and is located in the top center of the device. After the shipping lock is removed, it
should be stored on the back panel of the device for future use.
To remove and store the shipping lock:
Installing the Tape Autoloader 34