HP StorageWorks 1/8, User'S And Service Manual, Page: 57 / 204

• DHCPv4 Addressing — When Enabled, the device will request an IP address from a DHCP server
each time the device is booted.
• IPv4 Address — the Autoloader network address
• Subnet Mask — The network mask of the autoloader controller used when DHCP Addressing is
not Enabled.
• Default Gateway — the gateway used when DHCP Addressing is not Enabled.
When IPv6 Addressing is Enabled, you can see, but not modify:
• Stateless Addressing — when Enabled, the device will generate an address for itself based on
the routing information obtained from a router advertisement and the MAC address. The device
can manage up to five global addresses at the same time, which can be assigned from different
routers.
• DHCPv6 Addressing — when Enabled, the Autoloader will request an IP address from a DHCP
server each time the device is booted.
• Static Addressing — when Enabled, the device will use a statically-configured address.
• Static Assigned Address — the IPv6 address when Static Addressing Enabled is On.
Status
Viewing dynamic device information
The Status: Autoloader page displays dynamic information about the device. When you click Refresh ,
the status is updated immediately.
Figure 30 Status: Autoloader page
.
You can see, but not modify, the following:
• Status — the overall status of the device
The device is fully operational and no user interaction is required.
User attention is necessary, but the device can still perform most operations.
User intervention is required and the device is not capable of performing some operations.
HP StorageWorks 1/8 G2 Tape Autoloader User and service guide 57