HP Kayak XA-s 02xx, User Manual, Page: 54 / 148

2 How to Install Accessories Inside Your PC Workstation
Installing Mass Storage Devices
42 English
3 If an error message appears, follow the instructions provided by the
Error Message Utility. When prompted, press
to run the Setup
program.
4 Select the Advanced menu, and the IDE Devices submenu. In the
Primary Master item, check that the details for the device have been
correctly detected by the
Setup program.
5 Press to save and exit Setup .
Refer to the operating system documentation for information on
formatting a drive.
NOTE
If an IDE drive is removed, switch on the computer. The system BIOS
will detect that the device is missing. Press
to confirm that you want
to remove the device. The system configuration will be updated
automatically.
Installing a Drive in a Front-Access Shelf
These instructions explain how to install a drive (such as a flexible disk
drive, a CD-ROM drive, CD-RW drive, or a tape drive) in one of the
front-access drive shelves. You should also refer to the manual supplied
with the drive for any additional installation instructions.
Before Installing an
IDE Device
Refer to the drive’s installation guide to see if you must set jumpers or if
there is a special installation procedure to follow.
Before Installing a
SCSI Device If you are installing a SCSI device, refer to the section “Before Installing
a SCSI Hard Disk” on page 35 before using the following instructions.
1 Disconnect the computer’s power cord and any telecommunications
cable.
2 Remove the computer’s cover (see page 23).
3 Slide out the power supply to provide better access to the disk drive
cables (see page 27).
geron.bk : geron-2.fb4 Page 42 Sunday, March 22, 1998 5:03 AM