39
XLS80e Fire Alarm Control Panels
Honeywell, Issue 9
March 2007
5.1.4 Change Device Configuration -
Modules
The following can be altered for modules:
a. The device type.
b. The zone or cell in which the device is
placed.
c. The device location text. Note that the zone
text is displayed but cannot be edited here
(it is edited in the Zone Text Editor, see
Section 6.3
).
d. Module supervision options (see
Section 13
for recommendations).
e. Verification delay times. See
Section 13
for
recommendations.
f. Priority options.
g. Silence and Pulse options.
5.1.4.1 Edit Device Type
Select the required TYPE. If no module exists
at the entered number, its type is NONE.
Available types are:
Type
Description
Physical Type
NONE Deleted - no module
exists at this address
MCP
Manual Call Point
MMX
BELL
Bell/sounder circuit or
loop-powered sounder
CMX
CTRL (generalised)
Control Function
CMX
MON
(generalised)
MONitoring function
MMX
SPRK Sprinkler Monitor
-
ASPR Aspirator Interface
-
AUX.
Auxiliary Module
ZMX
Low cost version of CDI
ZMX
CDI
Conventional
Detector Interface
CDI
LBM
Loop Booster Module
LBM
Note:
While sensor types are Physical device
types (they are determined by the
sensor hardware and must be selected
so as to match the actual sensor
installed at that address), module types
are Logical device types. These refer
to one of the physical module types as
shown in the table above.
TO
MAKE
SELECTION
Set device type - Loop n Module nn
1:
2:MCP MANUAL CALL POINT
3:BELL/SOUNDER
4:CONTROL MODULE
5:MONITOR MODULE
DELETE
Set device type - Loop n Module nn
6:SPRINKLER MODULE
7:ASPIRATOR INTERFACE
8:AUX INPUT
9:ZMX ZONE MONITOR
10:
CDI ZONE MONITOR
Set device type - Loop n Module nn
7:ASPIRATOR INTERFACE
8:AUX INPUT
9:ZMX ZONE MONITOR
10:CDI ZONE MONITOR
11:
LBM LOOP BOOSTER MODULE
