Chapter 2. NAMES AND FUNCTIONS OF PARTS
FUNC + PARA
:
Event configuration setting key
Press the
PARA key
while holding down the
FUNC key
in basic status display to
switch to the event configuration setting status.
FUNC + PID
:
Constant value control setting key
Press the
PID key
while holding down the
FUNC key
in basic status display to switch
to the event configuration setting status.
FUNC + PROG
:
Program setting (programming) key
Press the
PROG key
while holding down the
FUNC key
in the program run mode in
basic status display to go to the program setting (programming) status.
When the
PROG key
is pressed while holding down the
FUNC key
in the program
setting status, allows you to change the number of the program to be set.
FUNC + CLR
:
Program delete key
Press the
CLR key
while holding down the
FUNC key
during registration in the pro-
gram setting status to delete a setting or return to a default value.
FUNC + ENTER
:
Segment insert/remove/RAMP/selection key
Press the
ENTER key
while holding down the
FUNC key
to go to the segment
insert/delete panel during SP and time setting in the program setting status.
Pressing the
ENTER key
while the
FUNC key
is held down during SP registration in
the program setting status allows you to switch between RAMP-X and RAMP-T as well
as RAMP-X and RAMP-E.
↑
+ PROG
: Program copy key
Press the
PROG key
while holding down the
↑
key
in program run READY mode in
basic display status to go to the program copy panel.
FUNC + CLR + MESSAGE
:
General reset key
Press the
CLR
and
MESSAGE keys
simultaneously while holding down the
FUNC
key
in the READY AUTO mode in the basic display status to go to the general reset
verification panel.
■
Loader jack
This jack allows the connection of a loader.
Do not insert plugs other than loader plugs.
The loader jack is not isolated from internal digital circuits.
When not in use, always replace the cap.
2-7
