Honeywell A700, Hardware Reference Manual, Page: 195 / 334

IMPORTANT
VoiceConsole will still report that the device and 8680i are paired even after following the
procedure below. This is a known issue.
1. Verify the 8680i is connected and that the BluetoothScannerConnectionMenuEnable
parameter is set to "1".
2. Select the menu option Unpair Bluetooth scanner by pressing the device - button three
times.
l
This menu option is only available if a scanner is connected.
3. The device speaks "Unpairing Bluetooth scanner".
l
The device ring LED begins spinning yellow.
l
The device buttons are disabled while unpairing the scanner.
4. The device will speak "Scanner unpaired" and then "Goodnight".
Honeywell 8670 Wireless Ring Scanner
NOTE
Refer to the
8670 User Guide for additional information and configuration bar codes.
Device as Initiator
Configure 8670 Scanner
l
The 8670 scanner must be set to Host Reconnect Mode (the 8670 will attempt to connect
to the device host, and if disconnected the device will manage the reconnection).
l
The 8670 must be configured to add termination characters (i.e., <CR><LF>).
1. Restore factory defaults by scanning the Remove Custom Defaults and Activate Defaults bar
codes.
2. Scan the Host Reconnect Mode bar code.
3. Scan the bar code to add a carriage return and line feed as termination characters.
Additional information:
l
The 8670 User Guide contains bar codes to set other combinations of termination
characters. To add a different termination suffix, scan the SUFBK2 (Add Suffix) bar code,
then scan the bar codes for the desired suffix.
173 Voice Device and Headset Hardware Reference Guide