12-6
c. BRUSH REPLACEMENT
1) Cut off the brush lead at the point shown and remove the
brush.
2) Remove the remaining brush lead and deposited solder
from the terminal.
3) Hold a new brush in the same direction of the removed
brush. Put a new plate over the new brush and terminal and
press it using a pair of pliers as shown.
4) Solder the plate on the terminal.
• Before soldering, heat the pressed part of the plate well to
make sure the solder reaches the end of the pressed part.
• Prevent the solder from flowing down the brush lead.
• Do not allow the solder to run down onto the field
winding of the yoke.
[1] Cut here
[4]
TERMINAL
[3]
BRUSH LEAD
[2]
BRUSH
[2] Press here
[1]
TERMINAL
[2] Press here
[3]
NEW BRUSH
[4]
PLATE
[1] Solder here
[4]
PRESSED PART
[3]
SOLDER
[2] SOLDERING IRON
cap.12 EU65is 6500is 07.12.17 5:04 PM ページ12-6
