2-27
b. ENGINE
Perform troubleshooting with a known good 12V battery.
• Hard Starting
Check whether the indicators (output,
overload, oil alert) and i-Monitor are on
when the ignition switch is turned ON.
Add fuel and restart the engine.
ON
OFF
Check whether the oil alert indicator is ON
and "OIL" is displayed on the i-Monitor.
See
in "TROUBLESHOOTING BY
ERROR CODE" (P. 2-14).
OIL
Not displayed
Displayed
Check whether the starter motor is
operating with the ignition switch turned to
START.
Perform "Starter Motor Does Not Turn"
troubleshooting (P. 2-39).
Operates
Does not operate
Check whether an error code is displayed
on the i-Monitor.
Refer to "Failure By Error Code" (P. 2-11).
Not displayed
Displayed
Check the fuel level in the tank.
Add fuel and then restart the engine.
Sufficient
Insufficient
Remove the spark plug and check for wet or
fouled electrodes.
• Clean the electrodes and restart.
• If flooding is severe, check the carburetor
float valve (P. 4-7).
Check for restriction in the carburetor port,
nozzle, and jet.
Normal
Wet
Dry
Loosen the drain screw and check whether
fuel is reaching the carburetor.
Check for restriction in the fuel strainer, fuel
valve or fuel tube (P. 7-2).
Fuel reaching the carburetor
Not reaching
the carburetor
Perform the spark test (P. 2-38).
Perform "No Spark at Spark Plug"
troubleshooting (P. 2-35).
No spark or
weak spark
To P. 2-28
Good spark
cap.02 EU65is 6500is (Eu).qxd 07.12.17 4:25 PM ページ2-27