Hioki MEMORY HiCORDER 8855, Instruction Manual

Page: 70 / 264

50
────────────────────────────────────────────────────
4.2 Operation Sequence (FFT)
────────────────────────────────────────────────────
See Chapter 2
Settings on the STATUS screen
Press the
STATUS
key to display
the STATUS screen.
Preparation
Basic Settings
Function Select the FFT function.
FFT mode
Select the using channels (1
channel or 2 channels)
Frequency range Set the maximum value of
frequency range.
Number of FFT point Set the number of points for
FFT analysis
Window function Set the window function to get
input signal.
Display format Set the display and print formats
for the input signal or analysis
result.
For single and dual screens, set
peak value display.
Reference data Set the new data or memory
waveform data for the FFT
analysis.
FFT analysis mode FFT analysis mode
Analysis channel
X- and Y- axis display
Display scale
Averaging Set the averaging type and
count.
Interpolation Select waveform display format
(dot/line)
Waveform
evaluation (item setting/stop mode)
See
Section 4.3
Installation of the Instrument
Turn on the power
Connect the inputs
Setting the printer
Setting the print
mode
Select the format, waveform, or
numerical value should be used
to output measured data and
calculation results.
Setting the print
mode
Select whether or not to print out
the waveform automatically after
it is captured.
See
Section 4.4
Saving the file
Auto save function Select whether or not to save the
waveform automatically after it is
captured.
See
Section 4.5
4.2 Operation Sequence (FFT)