Hioki MEMORY HiCORDER 8855, Instruction Manual

Page: 187 / 264

167
────────────────────────────────────────────────────
9.1 Waveform GO/NG Evaluation (MEM, FFT Function, Power Monitor Function)
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Setting the GO/NG stop mode
Setting the evaluation area
Executing waveform GO/NG
evaluation
Setting the waveform evaluation
mode
Measurement starts
Loading
Creating
new area
OFF
OUT
ALL-OUT
GO
NG
GO&NG
Load the created evaluation area and settings. Use the
File screen.
Create the evaluation area by using the eight types of
commands.
Store the evaluation area in memory, and after that,
store the data on the media on the File screen.
Disable waveform evaluation.
Return NG if any part of the waveform leaves the
evaluation area.
Return NG if the entire waveform leaves the evaluation
area.
Stop recording on GO result.
Stop recording on NG result.
Stop recording on GO or NG result.
Pressing the
START
key starts measurement.
Data acquisition starts when the trigger conditions
are met.
When the input waveform meets the stop
conditions, signals are output from the GO and NG
terminals. Auto-print and auto-save are also set.
When sequential save is used in memory function,
measurement data is recorded to the blocks.
Chapter 9
Waveform Evaluation Function
9.1 Waveform GO/NG Evaluation (MEM, FFT Function,
Power Monitor Function)
The waveform evaluation function can be used from the Memory function
(single screen, X-Y single screen), FFT function, or the Power monitor
function (when the 9549 FUNCTION UP DISK is installed).
GO (pass) or NG (fail) evaluation of the input signal waveform can be
performed using an evaluation area specified by the user.
This can serve to detect irregular waveforms.
Depend on evaluation result, GO and NG terminal output the signal.
Displaying all channels can be used for GO/NG evaluation.