Hioki MEMORY HiCORDER 8855, Instruction Manual

Page: 31 / 264

11
────────────────────────────────────────────────────
2.2 Power Supply and Ground Connections
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
2.2.1 Connecting the AC Power Supply
WARNING
Check the following points before connecting the instrument
to a power supply. Take care never to exceed the power
supply ratings given below, to avoid the risk of electric shock
and damage to the instrument.
(1) Power supply matches Rated supply voltage (100 to 240 V
AC: Voltage fluctuations of 10% from the rated supply
voltage are taken into account.) and rated supply frequency
(50/60 Hz).
(2) The AC power switch of the 8855 is set to OFF.
(3) Use only the supplied AC power cord.
When supplying power with an inverter or an uninterruptible
power supply (UPS), use a device that complies with the
following conditions. To avoid the risk of electric shock and
damage to the instrument, do not use devices that have a
voltage frequency outside the specified range, or that output
square waves.
(1) Voltage: 100 V to 240 V AC
(2) Power frequency: 50/60 Hz
(3) Sine wave output (Do not use devices that have an
unstable output, even if the output is sinusoidal.)
The 8855 has no protective ground terminal, but is intended to
be connected to a ground wire via the grounded three-core
power cord supplied. In order to avoid electric shock
accidents, be sure to connect the grounded three-core power
cord supplied to a power supply socket one of whose
terminals is properly grounded.
NOTE
2.2 Power Supply and Ground Connections
1. Verify that the AC power switch of the 8855 is set to OFF.
2. Plug the grounded three-core power cord supplied into the
AC power connector on the right side of the 8855.
3. Plug the power cord into an AC outlet corresponding to the
rating of the 8855.
The fuse is incorporated in power supply. It is not user-replaceable. If a
problem is found, contact your nearest dealer.