Hioki DSM-8542, Instruction Manual, Page: 62 / 140

52
Set the value input by pressing the [ENTER] key.
Press the [ENTER] key to finish setting and to return to the Measurement
screen.
The setting ranges for UPPER and LOWER are limited depending on the
measuring mode. See Table 5.10.
Table 5.10 Setting Ranges by Measuring Mode
Measuring Mode Setting Range
Resistance
measurement 1.0000E+01~3.0000E+16
Ω
Current
measurement 3.0000E-14~1.0000E-02A
Surface resistivity
measurement 1.0000E+01~3.0000E+16
Ω
Rs
Volume resistivity
measurement 1.0000E+01~3.0000E+16
Ω
Rv
[Notice]
Exercise caution when setting sequences. When setting UPPER and
LOWER, an error results if the condition of (UPPER) > (LOWER) is not
established, disabling keying of the [ENTER] key.
(3) Result display of comparison measurement
The side mark for “COMP ON” on the right in the screen flashes if the decision
result of a comparison measurement is <NG>.
If a decision result is <GO>, a beep tone will be on in case “beep tone on” is set.
The decision result “<GO>” will be output to the connector of the handler
interface on the rear.
[Notice]
Comparison measurement is made only against the absolute value of each
measurement item and comparison against deviation or % cannot be made.
5.3.3 Deviation display
(1) Setting deviation display
Press the [
△
MOD] (SET DEVIATION MODE PARAMETER) key on the
measurement screen. The screen will change to the deviation (difference or
ratio) display and setting screen. (See Fig. 5.20)
Ｄ Ｅ Ｖ Ｉ Ａ Ｔ Ｉ Ｏ Ｎ Ｍ Ｏ Ｄ Ｅ Ｐ Ａ Ｒ Ａ Ｍ Ｅ Ｔ Ｅ Ｒ
Ｍ Ｏ Ｄ Ｅ ： Ｏ Ｆ Ｆ ／ Ｄ Ｅ Ｖ ／ Ｐ Ａ Ｒ
Ｃ Ｈ １ Ｒ Ｅ Ｆ ： ［ １ ． ０ ０ ０ ０ Ｅ ＋ １ ２ ］ Ω
Ｃ Ｈ ２ Ｒ Ｅ Ｆ ： ［ ２ ． ０ ０ ０ ０ Ｅ ＋ １ ２ ］ Ω
Ｃ Ｈ ３ Ｒ Ｅ Ｆ ： ［ ３ ． ０ ０ ０ ０ Ｅ ＋ １ ２ ］ Ω
Ｃ Ｈ ４ Ｒ Ｅ Ｆ ： ［ ４ ． ０ ０ ０ ０ Ｅ ＋ １ ２ ］ Ω
Fig. 5.20 Deviation Display and Setting Screen