Hioki DSM-8542, Instruction Manual, Page: 16 / 140

6
2.2.7 Measuring sequence program
Up to ten measuring sequence patterns of discharge, charge, measurement and
discharge can be programmed.
Description
Program sequence (1) Discharge 1, (2) charge, (3) measurement (4) discharge 2
Settable patterns
10
Set time range 0.0 ~ 999.9s
2.2.8 Storage and display functions of measured data
(1) Measured data buffer
Measured data up to 1000 data groups for four individual channels is
sequentially stored and displayed by scrolling.
Measured data is sequentially stored and up to 1000 most recent data groups
are displayed on the stored measurement data screen.
Note: Stored data is cleared when the power is shut down.
(2) Histogram counter
Measured values are classified according to thresholds set independently for
the four channels and the numbers of samples falling in threshold ranges are
displayed in a bar graph.
Measured values are classified into ten types and numbers of data groups are
stored by digitally counting them by a counter.
Thresholds are set for the individual measuring modes and are indicated on the
screen in a bar graph. Thresholds are set within the measuring range
2.2.9 Operability and display
(1) Keyboard
Rubber key switches
Key clicking tone on or off can be selected
Key lock (prevention of malfunction in the Remote mode) on or off can be
selected
(2) Displays
1) Liquid crystal display 240x64dot graphic LCD (30 columns, 8 rows)
Backlight (Yellowish green LEDs)
Character size
Measured result 4 x 2 size
Measuring conditions Full size
Bar graph display
2) High-voltage warning display Red LED lit if higher than about 30V
2.2.10 Resume function
When the power supply goes off, the set parameters are automatically stored. When the
power is turned on again, the operation is resumed at the set parameters that are
automatically stored, except the voltage impression state.