Hioki DSM-8542, Instruction Manual, Page: 104 / 140

94
Table 7.3 Setting Control Program Messages 13/13
Mnemonic Description Format
*CLS Status register clear
See Fig. 7.4. [Format]
*CLS
*SPE Sets the service request enable register.
d1 (0 ~ 255)
See Fig. 7.5 and Table 7.5. [Format]
*SRE d1
d1: NR1 format
*SPE? Query of data in the service request enable
register.
d1 (0 ~ 63, 128 ~ 191)
[Note]
Bit 6 cannot be set in *SRE. [Format]
*SRE
[Response]
d1: NR1 format
*STB? Query of data in the status byte register.
d1 (0 ~ 255)
See Table 7.5. [Format]
*STB?
[Response]
d1: NR1 format
*ESE Sets the standard event status enable register.
d1 (0 ~ 255)
See Table 7.6 and Fig. 7.6. [Format]
*ESE d1
d1: NR1 format
*ESE? Query of data in the standard event status
enable register.
Response data is same as setting. [Format]
*ESE?
[Response]
d1: NR1 format
*ESR? Query of data in the standard event status
register.
d1 (0 ~ 255)
See Table 7.6 and Fig. 7.6.
[Note]
Data will be cleared simultaneously with
response output. [Format]
*ESR?
[Response]
d1: NR1 format
*RST DSM initialize
Initializes all settings to values set during
preshipment inspection at the factory.
Shuts down if in start state.
[Format]
*RST
*OPC Sets OPC bit of the standard event status
register after all operations being executed are
finished.
This command is used for detecting end of
commands that are time-consuming to process. [Format]
*OPC
*OPC? Returns “1” after all operations being executed
are finished.
Response d1:1 [Format]
*OPC?
[Response]
d1: NR1 format