Hioki DSM-8542, Instruction Manual, Page: 43 / 140

33
Table 5.5 Setting keys and function keys for setting screen change
Setting Key Function Key Setting Screen
[ COMP ] Comparison Measurement Setting screen (See 5.2.2)
[ DATA ]
[ F1 ] HIST
[ F2 ] SETH
[ F3 ] CLRH
[ F4 ] CLRD
[ F5 ] ROLL Acquired Data screen (See 5.2.4 onward)
Histogram display screen
Histogram display threshold setting screen
Histogram counter clear screen
Measured data buffer clear screen
Measured data buffer display screen
[
△
MOD ]
Deviation Value Display and Setting screen (See 4.3.4)
[ ELEC ] Electrode Setting screen (See 4.3.5)
[ SETUP ]
[ F1 ] CONF
[ F2 ] SELF
[ F3 ] CAL
[ F4 ] POWR Environment Setting screen (See 4.3.6~ onward)
External interface setting screen
Self-diagnosis test execute screen
Self-diagnosis test execute screen
Self-calibration setting screen
[ PROG ] Program create screen (See 4.3.11)
[ OPEN ] Open Correction Value Setting screen (See 4.3.12)
5.2.2 Setting measuring mode
This meter has four measuring modes capable of measuring resistance, current, surface
resistivity and volume resistivity.
Set a desired measuring mode as follows.
(1) Key operation
(a) Press the [F2] MODE key for mode selection.
(NOTE: The modes are displayed on the Measured Value Display screen.)
(b) Each pressing of the [F2] MODE key sequentially selects resistance
measurement, current measurement, surface resistivity measurement and
volume resistivity measurement.
(2) Mode display
The individual measuring modes are displayed in the units displayed in the
measured value display section.
Measuring Mode Unit Indication
Resistance measurement
Ω
Current measurement A
Surface resistivity measurement
Ω
Rs
Volume resistivity measurement
Ω
Rv
[Notice]
The actual unit for surface resistivity measurement is [
Ω
].
The actual unit for volume resistivity measurement is [
Ω
·cm].