128
―――――――――――――――――――――――――――――――――――――――
11.3 Setting the Trigger Types
―――――――――――――――――――――――――――――――――――
Trigger Screen
1 2 3 4
Waveform Screen
Triggering will occur when the input
signal crosses the threshold value
(the trigger level) from below going
upwards.
Triggering will occur when the input
signal crosses the threshold value
(the trigger level) from above going
downwards.
1
2
3
Selection
Memory recorder
OFF, 0.1, 0.2, 0.5, 1.0, 2.0 DIV
(When the magnification ratio:
×
1)
Recorder
X-Y CONT recorder
OFF, ON
Method (on the trigger screen and waveform screen)
This example illustrates settings for channel 1 (A).
The channel 2 (B) is also set in the same manner.
Using the
CURSOR
keys, move the flashing cursor to the
items designated by the numbers in the figure and make
the settings.
1. Set the type of trigger: Select
"
LEVEL
".
2. Set the trigger level: Using the
+
and
−
keys, set the threshold
value (voltage value).
3. Select the trigger direction (slope):
Set by using the
+
and
−
keys.
Selection
4. Set the trigger filter (the trigger screen only):
Set by using the
+
and
−
keys.
This setting cannot be made on the waveform screen.
Depending on the function, the contents which can be set
vary.
Summary of Contents for 8804
