The system will immediately alarm when it detects a triggering event after the system is
armed. There is a configurable interval timer between the alarm activation and siren output
"Siren Delay Time (Perimeter Alarm) 0 to 600 Seconds". This option allows you to check the
alarm and cancel the siren output during the interval time in case of false alarm.
When the zone is armed, you can set the peripheral alarm delayed time in Partition
Management → Schedule & Timer . You can also mute the siren in the delayed time.
Silent Panic Zone
This zone type is active 24hrs, it is used for Panic or HUD (Hold Up Devices) not smoke
sensors or break glass detectors.
Panic Zone
The zone activates all the time. It is usually used in the sites equipped with panic button,
smoke detector and glass-break detector.
Fire Zone
The zone activates all the time with sound/siren output when alarm occurs. It is usually used
in fire hazardous areas equipped with smoke detectors and temperature sensors.
Gas Zone
The zone activates all the time with sound/siren output when alarm occurs. It is usually used
in areas equipped with gas detectors (e.g., the kitchen).
Medical Zone
The zone activates all the time with beep confirmation when alarm occurs. It is usually used
in places equipped with medical emergency buttons.
Timeout Zone
The zone activates all the time. The zone type is used to monitor and report the "ACTIVE"
status of a zone, but it will only report and alarm this status after the programmed time has
expired. (1 to 599) Seconds. It can be used in places equipped with magnetic contacts that
require access but for only a short period (e.g., fire hydrant box's door or another external
security box door)
Key Zone
The linked partition will arm after being triggered, and disarm after being restored. In the
case of the tampering alarm, the arming and disarming operation will not be triggered.
Disabled Zone
Alarms will not be activated when the zone is triggered or tampered. It is usually used to
disable faulty detectors .
5. Enable Stay Arming Bypass, Chime, or Silent Alarm according to your actual needs.
Note
Some zones do not support the function. Refer to the actual zone to set the function.
6. Enable Enroll Wireless Detector, enter the serial No., and set the linked camera No.
AX Security Control Panel
32
Summary of Contents for AX DS-PWA32-H
Page 1: ...AX Security Control Panel...
Page 121: ...UD17056B...