Chapter 4 Device Configuring Using the Front Panel
Configuring the GbE Ports, Sockets and Routing Table
© 2012 Harmonic Inc.
51
ProView 7000 v.2.6, Rev. E
❑
PID – This menu only displays in PID mode.
❑
Status
■
Socket Configuration
– Socket Out – Use this menu to configure the 4 socket outs, namely:
• Socket 1
• Socket 2
• Socket 3
• Socket 4
All 4 sockets are associated to both IP ports. The sockets support IGMP v1, v2 and v3 and
automatically detect the version.
In each socket menu you can configure the following (GbE out):
• Destination IP Address – Only multicast IP addresses are supported. The default
address is
255.1.1.X
(X is the socket number).
• Destination UDP Port – The range is 0 – 65535. The default is
1000
.
• Source UDP Port – The range is 0 – 65535. The default is
1024
.
• Socket Status – Up or Down
In each socket menu you can configure the following (GbE in):
• Socket Admin Status – The options are:
· Up
· Down
• Traffic Parameters
· IP Address Type – The options are: Unicast, Multicast. The default is
Multicast
.
· IP Address – (Only displays if IP Address Type is Multicast.) You can configure the
same Destination IP Address and UDP Port for several sockets if you define the
Source Specific Multicast and the Source IP Addresses are different. When the IP
Address Type is Unicast, the ProView 7000™ uses the active port IP address. When
the IP Address Type is Multicast, you must enter the multicast IP address. The
default is
238.1.1.X
(X is the socket number).
· UDP Port – The range is 0 – 65535. The default is
1000
.
• Socket De-Jittering Mode – The default is
Normal
. The options are:
· Low – Low Delay
· Normal – Network jitter less than 50 msec.
· High – Network jitter less than 300 msec.
• Socket De-Jittering Status – Status display only.
• SSM – Options:
· Enable – You can configure one source IP address. Only packets with this source
address are processed.
· Disable – The device accepts all packets with destination IPs and ports that match
the socket regardless of their source IP.
■
Active Port
– Use this menu to select the active port when the mode is set to
In
. The
default is port 1.
