Chapter 7 Device Configuring Using EMS
Cross Connections
© 2012 Harmonic Inc.
131
ProView 7000 v.2.6, Rev. E
7.6.1.2
Program Cross Connection
You can cross connect programs from a multiplex in the
Multiplex Input
box with a multiplex
in the
Multiplex & Decoding Output
box and configure CAM descrambling.
The following options are available in the
Dynamic Program Connection Configuration
dialog:
■
Enabled – Define the operational status of the program.
■
Input – Display the name of the input multiplex which receives the stream and the number
of the multiplex program.
■
Output – Display the name of the output multiplex port where the stream is routed, the
number of the multiplex program routed to the port and the PID offset.
■
Descrambling – Enable descrambling the program and select the CAM used for the
descrambling. If no CAM is associated it is indicated here.
■
ES Descrambling – To use this feature you must first configure the
Descrambling
box. There
are two descrambling modes to choose from, the default is Automatic:
❑
Automatic – All ESs in this program with a CAS ID that matches the CAM are configured
for descrambling.
❑
Selective – Select which input PIDs to descramble. You can add PIDs which are not in the
table. You must check at least one ES PID.
