Chapter 7 Device Configuring Using EMS
EMS Connection Wizard
© 2012 Harmonic Inc.
141
ProView 7000 v.2.6, Rev. E
7.8.1
Setting Program Cross-Connection using the Connection Wizard
To set a cross-connection by using the Connection Wizard:
1. Click
Connection Wizard
on the EMS toolbar.
2. Select
Input Program to Output Port
and click
Next
.
A list of multiplex inputs available for selection displays.
3. Select an Input Multiplex Port and click
Next>>
.
A list of programs available at the selected input displays.
4. Select an input program port and click
Next>>
.
A list of multiplex outputs available for selection displays.
5. Select an Output Multiplex and click
Next>>
.
The Cross-Connect Editor dialog displays.
6. Set the required parameters:
❑
Enabled
– Defines the operational status of the program.
❑
Input
– Displays the name of the input physical port which receives the stream and
the number of the multiplex program.
❑
Output
– Displays the name of the output physical port where the stream is routed
and the number of the multiplexed program routed to the port. You can configure a
new PID Offset.
❑
Descrambling
– Enables descrambling the program and selects the CAM used for the
descrambling.
7. Click
Create
to create the program cross-connect.
