© 2012 Harmonic Inc.
36
ProView 7000 v.2.6, Rev. E
Chapter 4
Device Configuring Using the Front Panel
Topics:
■
Configuring the DVB-S/S2 Input Port Properties
■
■
■
Configuring the GbE Ports, Sockets and Routing Table
■
■
■
4.1 Configuring
the
DVB
-S/S2 Input Port Properties
To configure the ProView 7000™ reception parameters:
1. Navigate
Root > Reception
.
2. If your device has more than one demodulator, select a satellite input menu, SAT 1–4.
3. Select
Configuration
.
Each menu item displays a value setup page.
The Configuration menu comprises the following:
■
Universal
/
Wide Universal
/
K
u
/
C Band Frequency
(DVB-S and DVB-S2) – Sets the receiving
frequency according to the satellite LNB transmitting frequency. The receiver controls the
LNB band by sending a 22 kHz signal. When the signal is sent, the LNB uses its High Band
Local Oscillator (L.O.). When the signal is not sent, the LNB uses its Low Band L.O.
Two local oscillators exist,
Universal
and
Universal Wide
one for each band to leverage full
spectrum.
❑
Universal Band
valid range:
• 22 kHz Low tone range – 10,700,000 – 11,900,000 [kHz]
• 22 kHz High tone range – 11,550,000 – 12,750,000 [kHz]
❑
Wide Universal Band
valid range:
• 22 kHz Low tone range – 10,700,000 – 11,900,000 [kHz]
• 22 kHz High tone range – 11,700,000 – 12,750,000 [kHz]
❑
K
u
Band
valid range (22 kHz Low and High tone) – 9,500,000 – 14,000,000 [kHz]
❑
C Band
valid range (22 kHz Low and High tone) – 4,000,000 – 5,000,000 [kHz]
■
L Band Frequency
(DVB-S and DVB-S2) – Sets the L-band frequency
Valid range – 950,000 to 21,150,000 [kHz].
■
Symbol Rate
– DVB-S and DVB-S2. Sets the L-band symbol rate.
Valid range – 1,000,000 – 45,000,000 [baud].
