Setting tHe event
You can make the setup for record in case of sensor detection, camera event or video loss detection.
Sensor detection
You can set the sensor's operating condition and connected camera, as well as alarm output and its duration.
menu > event > Sensor detection
•
Apply to other sensors : If you select <
apply to other sensors
>, the "
apply to other sensors
" confirmation
window will appear.
After selecting channels that the settings will be applied to, click on <
ok
> to apply them to the selected
channels.
•
Sensor Operation : Sets the operation mode of sensors.
- <
n.o (normal open)
> : Sensor is opened. If the sensor is closed, it generates alarm.
- <
n.c (normal close)
> : Sensor is closed. If the sensor is open, it generates alarm.
•
Cam : Select a channel to be connected to the sensor.
If selected camera, "
cam preset setup
" window appears.
Select a channel and setup the preset.
`
Preset setup can be done in PTZ mode.
•
Alarm out : Sets the alarm output method.
`
For alarm output, see the "
HDD Alarm Setting
" in "
Menu Setup
>
Setting the Device
" in the Table of Contents.
•
Duration : Sets the duration of alarm signal and alarm sound.
M
`
If you select <
Camera
> tab, you can configure the sensor operation settings of the network camera connected to each
channel.
`
If the connected network camera that has configured the alarm in/out settings triggers an alarm, NVR will perform the alarm out.
camera event
You can set the activation of events (motion detection, video analysis, audio event) sent from the camera, alarm
output method and alarm time.
menu > event > camera event
•
Apply to CH : If you select <
apply to cH
>, the "
apply to cH
" confirmation window will appear.
After selecting channels that the settings will be applied to, click on <
ok
> to apply them to the selected
channels.
•
CH : Click <
> to display the channel information table.
•
Camera Event : Select whether to use an event detection.
•
MD : You can specify whether to receive an event of camera's motion detection in the storage device.
`
To receive an event of camera's motion detection, you need to enable the camera motion detection.
•
Smart Search : Enables or disables the Smart Search option.
`
To use the smart search function, the smart search option must be set to <
ON
>.
See the "
Smart Search
" page under "
Search & Play
>
Search
" in the Table of Contents.
•
Cam : Select an event detection channel.
If you select a camera item, the "
camera preset
" screen will appear. Select a channel to connect and set the
preset.
`
You can set the preset in PTZ mode.
•
Alarm : Select the method for alarm output.
`
For alarm output, see the "
HDD Alarm Setting
" in "
Menu Setup
>
Setting the Device
" in the Table of Contents.
English
_39
●
menu
Setup
