H3C UniServer R2700 G3, User Manual

Page: 49 / 226

6-13
b.
Install the supercapacitor. Insert the cableless end of the supercapacitor into the
supercapacitor holder, pull the clip on the holder, insert the cable end of the supercapacitor
into the holder, and then release the clip, as shown in
Figure 6-20 .
NOTE:
•
For simplicity, the figure does not show the cable attached to the supercapacitor.
•
The installation method for different supercapacitors is the same. This figure is for
illustration only.
Figure 6-20 Installing the supercapacitor
c.
Connect the storage controller to the supercapacitor. Connect one end of the
supercapacitor extension cable to the supercapacitor cable and the other to the storage
controller. For more information about the connection method, see "
Connecting the flash
card and supercapacitor of the power fail safeguard module ."
CAUTION:
Make sure the extension cable is the correct one. For more information, see Table 6-1 .
9.
Connect front drive data cables to the Mezzanine storage controller. For more information, see
"
Connecting drive cables ."
10.
Install the removed riser cards. For more information, see " Installing riser cards and PCIe
modules ."
11.
Install the removed power supply air baffle. For more information, see " Installing air baffles ."
12.
Install the access panel. For more information, see " Installing the access panel ."
13.
Rack-mount the server. For more information, see " Rack-mounting the server ."
14.
Connect the power cord. For more information, see " Connecting the power cord ."
15.
Power on the server. For more information, see " Powering on the server ."
Verifying the installation
Log in to HDM to verify that the Mezzanine storage controller, flash card, and supercapacitor are
operating correctly. For more information, see HDM online help.