H3C UniServer R2700 G3, User Manual

Page: 68 / 226

6-32
6.
Install the drive in the slot, with the guide pins on the chassis aligned with the two holes in one
side of the optical drive, as shown in
Figure 6-46 .
Figure 6-46 Installing the SATA optical drive for the 4LFF drive configuration
7.
Connect the SATA optical drive cable. For more information, see " Connecting the SATA optical
drive cable ."
8.
Install the removed security bezel. For more information, see " Installing the security bezel ."
9.
Install the access panel. For more information, see " Installing the access panel ."
10.
Rack-mount the server. For more information, see " Rack-mounting the server ."
11.
Connect the power cord. For more information, see " Connecting the power cord ."
12.
Power on the server. For more information, see " Powering on the server ."
Installing a SATA optical drive on the 8SFF server
1.
Power off the server. For more information, see " Powering off the server ."
2.
Remove the server from the rack. For more information, see " Removing the server from a rack ."
3.
Remove the access panel. For more information, see " Removing the access panel ."
4.
Remove the security bezel, if any. For more information, see " Replacing the security bezel ."
5.
Install the optical drive by using a drive enablement option.
a.
Press the clip on the right side of the blank in the enablement option until the blank pops
out partially, and pull the blank out of the enablement option, as shown in
Figure 6-47 .