H3C UniServer R2700 G3, User Manual

Page: 60 / 226

6-24
Installing the NVMe VROC module
1.
Identify the NVMe VROC module connector on the system board. For more information, see
"System board components."
2.
Power off the server. For more information, see " Powering off the server ."
3.
Remove the server from the rack. For more information, see " Removing the server from a rack ."
4.
Remove the access panel. For more information, see " Removing the access panel ."
5.
Remove the chassis air baffle. For more information, see " Removing air baffles ."
6.
Insert the NVMe VROC module onto the NVMe VROC module connector on the system board,
as shown in
Figure 6-34 .
Figure 6-34 Installing the NVMe VROC module
7.
Install the removed chassis air baffle. For more information, see " Installing air baffles ."
8.
Install the access panel. For more information, see " Installing the access panel ."
9.
Rack-mount the server. For more information, see " Rack-mounting the server ."
10.
Connect the power cord. For more information, see " Connecting the power cord ."
11.
Power on the server. For more information, see " Powering on the server ."
Installing the 2SFF drive cage
Installing the front 2SFF drive cage (8SFF server only)
Only the 8SFF server supports installing a front 2SFF drive cage.
To install the front 2SFF drive cage:
1.
Power off the server. For more information, see " Powering off the server ."
2.
Remove the server from the rack. For more information, see " Removing the server from a rack ."
3.
Remove the access panel. For more information, see " Removing the access panel ."
4.
Remove the screws that secure the drive cage blank from the server, and then pull the blank out
of the chassis, as shown in
Figure 6-35 .