H3C UniServer R2700 G3, User Manual

Page: 123 / 226

7-40
Verifying the replacement
Log in to HDM to verity that the drive backplane is in a correct state. For more information, see HDM
online help.
Replacing the SATA optical drive
WARNING!
To avoid bodily injury from hot surfaces, allow the server and its internal modules to cool before
touching them.
Replacing the SATA optical drive (4LFF server)
1.
Power off the server. For more information, see " Powering off the server ."
2.
Remove the server from the rack. For more information, see " Removing the server from a rack ."
3.
Remove the access panel. For more information, see " Removing the access panel ."
4.
Remove the security bezel, if any. For more information, see " Replacing the security bezel ."
5.
Disconnect the cable from the optical drive.
6.
Lift the optical drive by its right side, and then pull the optical drive out of the chassis, as shown
in
Figure 7-48 .
Figure 7-48 Removing the SATA optical drive from the 4LFF server
7.
Install a new SATA optical drive. For more information, see " Installing a SATA optical drive on
the 4LFF server ."
8.
Connect the optical drive cable.
9.
Install the removed security bezel. For more information, see " Installing the security bezel ."
10.
Install the access panel. For more information, see " Installing the access panel ."
11.
Rack-mount the server. For more information, see " Rack-mounting the server ."
12.
Connect the power cord. For more information, see " Connecting the power cord ."
13.
Power on the server. For more information, see " Powering on the server ."