7-3
6.
Power on the server. For more information, see "
Replacing the security bezel
1.
Insert the key provided with the bezel into the lock on the bezel and unlock the security bezel
(see callout 1 in
).
CAUTION:
To avoid damage to the lock, hold down the key while you are turning the key.
2.
Press the latch at the left end of the bezel, open the security bezel, and then release the latch
(see callouts 2 and 3 in
).
3.
Pull the right edge of the security bezel out of the groove in the right chassis ear to remove the
security bezel (see callout 4 in
).
Figure 7-3 Removing the security bezel
4.
Install a new security bezel. For more information, see "
Replacing a SAS/SATA drive
Guidelines
The drives are hot swappable.
To configure RAID settings after the drive is replaced, see the storage controller user guide for the
server.
Prerequisites
To replace a drive in a non-redundancy RAID array, back up data in the RAID array.
Procedure
1.
Remove the security bezel, if any. For more information, see "
2.
Observe the drive LEDs to verify that the drive is not selected by the storage controller and is
not performing a RAID migration or rebuilding. For more information about drive LEDs, see
"Drive LEDs."
