7-36
Figure 7-41 Removing a 10SFF drive expander module
6.
Place a new expander module in the chassis and fasten the captive screws.
7.
Connect cables to the drive expander module.
8.
Install the access panel. For more information, see "
."
9.
Rack-mount the server. For more information, see "
10.
Connect the power cord. For more information, see "
11.
Power on the server. For more information, see "
Verifying the replacement
Log in to HDM to verity that the 10SFF drive expander module is in a correct state. For more
information, see HDM online help.
Replacing a drive backplane
WARNING!
To avoid bodily injury from hot surfaces, allow the server and its internal modules to cool before
touching them.
Removing a drive backplane
1.
Power off the server. For more information, see "
2.
Remove the server from the rack. For more information, see "
Removing the server from a rack
."
3.
Remove the access panel. For more information, see "
."
4.
Remove the security bezel (if any) if you are removing the front drive backplane. For more
information, see "
."
5.
Remove the drives attached to the backplane. For more information, see "
6.
Disconnect cables from the backplane.
7.
Remove the drive backplane:
