H3C UniServer R2700 G3, User Manual

Page: 125 / 226

7-42
9.
Connect the optical drive cable.
10.
Install the removed security bezel. For more information, see " Installing the security bezel ."
11.
Install the access panel. For more information, see " Installing the access panel ."
12.
Rack-mount the server. For more information, see " Rack-mounting the server ."
13.
Connect the power cord. For more information, see " Connecting the power cord ."
14.
Power on the server. For more information, see " Powering on the server ."
Replacing the diagnostic panel
WARNING!
To avoid bodily injury from hot surfaces, allow the server and its internal modules to cool before
touching them.
To replace the diagnostic panel:
1.
Power off the server. For more information, see " Powering off the server ."
2.
Remove the security bezel, if any. For more information, see " Replacing the security bezel ."
3.
Remove the diagnostic panel, as shown in Figure 7-51 :
a.
Press the release button on the diagnostic panel.
The diagnostic panel pops out.
b.
Hold the diagnostic panel by its front edge to pull it out of the slot.
Figure 7-51 Removing the diagnostic panel
4.
Install a new diagnostic panel. For more information, see " Installing a diagnostic panel ."
5.
Install the removed security bezel. For more information, see " Installing the security bezel ."
6.
Connect the power cord. For more information, see " Connecting the power cord ."
7.
Power on the server. For more information, see " Powering on the server ."
Replacing the chassis-open alarm module
WARNING!
To avoid bodily injury from hot surfaces, allow the server and its internal modules to cool before
touching them.
The server supports the following types of chassis-open alarm modules:
•
Independent chassis-open alarm module.
•
Chassis-open alarm module attached to the front media module.