7-4
3.
Remove the drive, as shown in
:
{
To remove an SSD, press the button on the drive panel to release the locking lever, and then
hold the locking lever and pull the drive out of the slot.
{
To remove an HDD, press the button on the drive panel to release the locking lever. Pull the
drive 3 cm (1.18 in) out of the slot. Wait for a minimum of 30 seconds for the drive to stop
rotating, and then pull the drive out of the slot.
Figure 7-4 Removing a drive
4.
Install a new drive. For more information, see "
."
5.
Install the removed security bezel, if any. For more information, see "
Verifying the replacement
Use one of the following methods to verify that the drive has been replaced correctly:
•
Verify the drive properties (including its capacity) by using one of the following methods:
{
Access HDM. For more information, see HDM online help.
{
Access the BIOS. For more information, see the BIOS user guide for the server.
{
Access the CLI or GUI of the server.
•
Observe the drive LEDs to verify that the drive is operating correctly. For more information
about drive LEDs, see "Drive LEDs."
Replacing an NVMe drive
Guidelines
NVMe drives support hot insertion and managed hot removal.
To configure RAID settings after the drive is replaced, see the storage controller user guide for the
server.
Procedure
1.
Identify the NVMe drive to be removed and perform managed hot removal for the drive. For
more information about managed hot removal, see "Appendix C Managed hot removal of
NVMe drives."
2.
Remove the security bezel, if any. For more information, see "
3.
Remove the drive, as shown in
:
a.
Press the button on the drive panel to release the locking lever.
b.
Hold the locking lever and pull the drive out of the slot.
