H3C UniServer R2700 G3, User Manual

Page: 61 / 226

6-25
Figure 6-35 Removing the drive cage blank
5.
Insert the 2SFF drive cage into the slot and then use screws to secure it into place, as shown
in
Figure 6-38 .
Figure 6-36 Installing the 2SFF drive blank
6.
Connect the AUX signal cable, data cable, and power cord to the front 2SFF drive backplane.
For more information about cable connection to the front 2SFF SAS/SATA drive backplane and
the front 2SFF NVMe drive backplane, see
Figure 8-9 and Figure 8-15 , respectively.
7.
Install drives in the front 2SFF drive cage. For more information, see " Installing SAS/SATA
drives ."
8.
Install the access panel. For more information, see " Installing the access panel ."
9.
Rack-mount the server. For more information, see " Rack-mounting the server ."
10.
Connect the power cord. For more information, see " Connecting the power cord ."
11.
Power on the server. For more information, see " Powering on the server ."