H3C S5500-SI Series, Operation Manual

Page: 933 / 1217

2-5
Authentication
mode
Configuration Description
Configure to authenticate users using
the local password
Password
Set the local password
Refer to Console Port Login
Configuration with Authentication
Mode Being Password
for details.
Configure to authenticate users locally
or remotely
Configure the authentication mode
Scheme
Create or enter a local user, set the
authentication password, specifies the
level and service type for AUX users
Refer to Console Port Login
Configuration with Authentication
Mode Being Scheme
for details.
Changes of the authentication mode of Console port login will not take effect unless you exit and enter
again the CLI.
Console Port Login Configuration with Authentication Mode Being
None
Configuration Procedure
Follow these steps to perform Console port login configuration (with authentication mode being none ):
To do… Use the command… Remarks
Enter system view system-view —
Enter AUX user interface view user-interface aux 0 —
Configure not to authenticate
users
authentication-mode none
Required
By default, users logging in through
the Console port are not
authenticated.
Configuration Example
Network requirements
Assume the switch is configured to allow you to login through Telnet, and your user level is set to the
administrator level (level 3). After you telnet to the switch, you need to limit the console user at the
following aspects.
z
The user is not authenticated when logging in through the Console port.
z
Commands of level 2 are available to user logging in to the AUX user interface.
z
The baud rate of the Console port is 19200 bps.
z
The screen can contain up to 30 lines.
z
The history command buffer can contain up to 20 commands.