H3C S5500-SI Series, Operation Manual

Page: 342 / 1217

1-10
To do… Use the command… Remarks
Configure the RIP interface
to advertise a default route
rip default-route { { only |
originate } [ cost cost ] |
no-originate }
Optional
By default, a RIP interface can
advertise a default route if the
RIP process is configured with
default route advertisement.
The router enabled to advertise a default route does not receive default routes from RIP neighbors.
Configuring Inbound/Outbound Route Filtering
The device supports route filtering. You can filter routes by configuring the inbound and outbound route
filtering policies by referencing an ACL or IP prefix list. You can also configure the router to receive only
routes from a specified neighbor.
Follow these steps to configure route filtering:
To do… Use the command… Remarks
Enter system view system-view ––
Enter RIP view rip [ process-id ] ––
Configure the filtering
of incoming routes
filter-policy { acl-number | gateway
ip-prefix-name | ip-prefix ip-prefix-name
[ gateway ip-prefix-name ] } import
[ interface-type interface-number ]
Required
Not configured by default
Configure the filtering
of outgoing routes
filter-policy { acl-number | ip-prefix
ip-prefix-name } export [ protocol
[ process-id ] | interface-type
interface-number ]
Required
Not configured by default
z
Using the filter-policy import command filters incoming routes. Routes not passing the filtering
will be neither installed into the routing table nor advertised to neighbors.
z
Using the filter-policy export command filters outgoing routes, including routes redistributed with
the import-route command.
Configuring a Priority for RIP
Multiple IGP protocols may run in a router. If you want RIP routes to have a higher priority than those
learned by other routing protocols, you can assign RIP a smaller priority value to influence optimal route
selection.
Follow these steps to configure a priority for RIP: