7-3
Follow these steps to control Telnet users by source MAC addresses:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Create a basic ACL or enter
basic ACL view
acl
number
acl-number
[
match-order
{
config
|
auto
} ]
As for the
acl number
command, the
config
keyword
is specified by default.
Define rules for the ACL
rule
[
rule-id
] {
permit
|
deny
}
rule-string
Required
You can define rules as needed
to filter by specific source MAC
addresses.
Quit to system view
quit
—
Enter user interface view
user-interface
[
type
]
first-number
[
last-number
]
—
Apply the ACL to control Telnet
users by source MAC
addresses
acl
acl-number inbound
Required
The
inbound
keyword specifies
to filter the users trying to Telnet
to the current switch.
Layer 2 ACL is invalid for this function if the source IP address of the Telnet client and the interface IP
address of the Telnet server are not in the same subnet.
Configuration Example
Network requirements
Only the Telnet users sourced from the IP address of 10.110.100.52 and 10.110.100.46 are permitted to
log in to the switch.
Figure 7-1
Network diagram for controlling Telnet users using ACLs
Switch
10.110.100.46
Host A
IP network
Host B
10.110.100.52
Configuration procedure
# Define a basic ACL.
<Sysname> system-view
Summary of Contents for S5500-SI Series
