H3C S5500-SI Series, Operation Manual

Page: 1130 / 1217

1-18
Configuration prerequisites
Enable the DLSw function on the peer device before DLSw test.
Configuring a DLSw test
Follow these steps to configure a DLSw test:
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as
DLSw and enter test type view
type dlsw Required
Configure the destination
address for a test operation
destination ip ip-address
Required
By default, no destination IP
address is configured for a test
operation.
Configure the source IP
address of a probe request in a
test operation
source ip ip-address
Optional
By default, no source IP
address is specified.
The source IP address must be
that of an interface on the
device and the interface must
be up. Otherwise, the test will
fail.
Configure common optional
parameters
See Configuring Optional
Parameters Common to an
NQA Test Group Optional
Configuring the Collaboration Function
Collaboration is implemented by establishing collaboration objects to monitor the detection results of
the current test group. If the number of consecutive probe failures reaches the threshold, the configured
action is triggered.
Follow these steps to configure the collaboration function:
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view nqa entry admin-name operation-tag —
Enter test type view of the
test group type { dhcp | dlsw | ftp | http |
icmp-echo | snmp | tcp | udp-echo }
The collaboration function
is not supported in UDP
jitter or voice tests.
Create a collaboration
object
reaction item-num checked-element
probe-fail threshold-type
consecutive occurrences [ action-type
{ none | trigger-only } ]
Required
Not created by default.
Exit to system view
quit
—