H3C S5500-SI Series, Operation Manual

Page: 845 / 1217

1-10
Complete the following tasks to configure RRPP:
Task Remarks
Creating an RRPP Domain
Required
Perform this task on all nodes in the RRPP domain.
Configuring Control VLANs
Required
Perform this task on all nodes in the RRPP domain.
Configuring Protected VLANs
Required
Perform this task on all nodes in the RRPP domain.
Configuring RRPP Ports
Required
Perform this task on all nodes in the RRPP domain.
Configuring
RRPP Rings
Configuring RRPP Nodes
Required
Perform this task on all nodes in the RRPP domain
Activating an RRPP Domain
Required
Perform this task on all nodes in the RRPP domain.
Configuring RRPP Timers
Optional
Perform this task on the master node in the RRPP
domain.
Configuring an RRPP Ring Group
Optional
Perform this task on the edge node and
assistant-edge node in the RRPP domain.
z
RRPP does not have an auto election mechanism, so you must configure each node in the ring
network properly for RRPP to monitor and protect the ring network.
z
Before configuring RRPP, you need to construct a ring-shaped Ethernet topology physically.
Creating an RRPP Domain
When creating an RRPP domain, specify a domain ID, which uniquely identifies an RRPP domain. All
devices in the same RRPP domain must be configured with the same domain ID.
Make this configuration on devices you want to configure as nodes in the RRPP domain.
Follow these steps to create an RRPP domain:
To do… Use the command… Remarks
Enter system view system-view —
Create an RRPP domain and
enter RRPP domain view
rrpp domain domain-id Required