H3C S5500-SI Series, Operation Manual

Page: 680 / 1217

1-17
EAPOL Packet: Tx 16331, Rx 102
Sent EAP Request/Identity Packets : 16316
EAP Request/Challenge Packets: 6
EAP Success Packets: 4, Fail Packets: 5
Received EAPOL Start Packets : 6
EAPOL LogOff Packets: 2
EAP Response/Identity Packets : 80
EAP Response/Challenge Packets: 6
Error Packets: 0
1. Authenticated user : MAC address: 0002-0000-0011
Controlled User(s) amount to 1
In addition, the port allows an additional user whose MAC address has an OUI among the specified
OUIs to access the port. You can use the following command to view the related information:
<Switch> display mac-address interface gigabitethernet 1/0/1
MAC ADDR VLAN ID STATE PORT INDEX AGING TIME(s)
1234-0300-0011 1 Learned GigabitEthernet1/0/1 AGING
--- 1 mac address(es) found ---
Configuring the macAddressElseUserLoginSecure Mode
Network requirements
The client is connected to the switch through GigabitEthernet 1/0/1. The switch authenticates the client
by the RADIUS server. If the authentication succeeds, the client is authorized to access the Internet.
Restrict port GigabitEthernet 1/0/1 of the switch as follows:
z
Allow more than one MAC authenticated user to log on.
z
For 802.1X users, perform MAC authentication first and then, if MAC authentication fails, 802.1X
authentication. Allow only one 802.1X user to log on.
z
Set fixed username and password for MAC-based authentication. Set the total number of MAC
authenticated users and 802.1X-authenticated users to 64.
z
Enable NTK to prevent frames from being sent to unknown MAC addresses.
See Figure 1-2 .
Configuration procedure
z
Configurations on the host and RADIUS servers are omitted.
1) Configure the RADIUS protocol
The required RADIUS authentication/accounting configurations are the same as those in Configuring
the userLoginWithOUI Mode .