1-2
install, and uninstall represent operations, corresponding to commands of
patch load
,
patch active
,
patch run
,
patch deactive
,
patch delete
,
patch install
, and
undo patch install
. For example, if you
execute the
patch active
command for the patches in the DEACTIVE state, the patches turn to the
ACTIVE state.
Figure 1-1
Relationship between patch state changes and command actions
Information about patch states is saved in file
patchstate
on the flash. It is recommended not to operate
this file.
IDLE state
Patches in the IDLE state are not loaded. You cannot install or run the patches, as shown in
(suppose the memory patch area can load up to eight patches).
The patches that are in the IDLE state will be still in the IDLE state after system reboot.
Summary of Contents for S5500-SI Series
