6-2
To do…
Use the command…
Remarks
Specify source IP
address/interface for Telnet
packets
telnet client source
{
ip
ip-address
|
interface
interface-type
interface-number
}
Optional
By default, no source IP
address/interface is specified.
z
The IP address specified must be a local IP address.
z
When specifying the source interface for Telnet packets, make sure the interface already exists.
z
Before specifying the source IP address/interface for Telnet packets, make sure the route between
the interface and the Telnet server is reachable.
Displaying the source IP address/Interface Specified for Telnet
Packets
Follow these steps to display the source IP address/interface specified for Telnet packets:
To do…
Use the command…
Remarks
Display the source IP
address/interface specified for
Telnet packets
display telnet client configuration
Available in any view
Summary of Contents for S5500-SI Series
