H3C S5500-SI Series, Operation Manual

Page: 10 / 1217

3-1
3
Features
The following sections provide an overview of the main features of each module supported by the
S5500-SI series.
Access Volume
Table 3-1 Features in Access volume
Features Description
Ethernet Interface
This document describes:
z
Combo Port Configuration
z
Basic Ethernet Interface Configuration
z
Configuring Flow Control on an Ethernet Interface
z
Configuring the Suppression Time of Physical-Link-State Change on
an Ethernet Interface
z
Configuring Loopback Testing on an Ethernet Interface
z
Configuring a Port Group
z
Configuring Storm Suppression
z
Setting the Interval for Collecting Ethernet Interface Statistics
z
Enabling Forwarding of Jumbo Frames
z
Enabling Loopback Detection on an Ethernet Interface
z
Configuring the MDI Mode for an Ethernet Interface
z
Testing the Cable on an Ethernet Interface
z
Configuring the Storm Constrain Function on an Ethernet Interface
Link Aggregation
Link aggregation aggregates multiple physical Ethernet ports into one
logical link. This document describes:
z
Basic Concepts of Link Aggregation
z
Configuring an Aggregation Group
z
Configuring an Aggregate Interface
z
Configuring a Load Sharing Mode for Load-Sharing Link Aggregation
Groups
Port Isolation
The port isolation feature allows you to isolate different ports within the
same VLAN. This document describes:
z
Introduction to Port Isolation
z
Configuring the Isolation Group
MSTP
MSTP is used to eliminate loops in a LAN. It is compatible with STP and
RSTP. This document describes:
z
Introduction to STP/RSTP/MSTP
z
Configuring MSTP