1-9
Displaying and Maintaining Hotfix
To do…
Use the command…
Remarks
Display the patch information
display patch information
Available in any view
Hotfix Configuration Examples
Hotfix Configuration Example
Network requirements
z
The software running on Device is of some problem, and thus hotfixing is needed.
z
The patch file
patch_xxx.bin
is saved on the TFTP server.
z
The IP address of Device is 1.1.1.1/24, and IP address of TFTP Server is 2.2.2.2/24. An available
route exists between Device and TFTP server.
Figure 1-6
Network diagram of hotfix configuration
Configuration procedure
1) Configure TFTP Server. Note that the configuration varies depending on server type and the
configuration procedure is omitted.
z
Enable the TFTP server function.
z
Save the patch file
patch_xxx.bin
to the directory of the TFTP server.
2) Configure
Device
Make sure the free flash space of the switch is big enough to store the patch file.
# Before upgrading the software, use the
save
command to save the current system configuration. The
configuration procedure is omitted.
# Load the patch file
patch_xxx.bin
from the TFTP server to the root directory of the Flash.
<Device> tftp 2.2.2.2 get patch_xxx.bin
# Install the patch.
<Device> system-view
[Device] patch install flash:
Patches will be installed. Continue? [Y/N]:y
Do you want to continue running patches after reboot? [Y/N]:y
Summary of Contents for S5500-SI Series
