H3C S5500-SI Series, Operation Manual

Page: 848 / 1217

1-13
z
For detailed information about the port link-type trunk command and port trunk permit vlan
{ vlan-id-list | all } command, refer to VLAN Commands in the Access Volume .
z
For detailed information about the undo stp enable command, refer to MSTP Commands in the
Access Volume .
z
The 802.1p priority of trusted packets on the RRPP ports must be configured, so that RRPP
packets take higher precedence than data packets when passing through the RRPP ports.
z
Do not enable OAM remote loopback function on an RRPP port. Otherwise, this may cause
temporary broadcast storm.
z
You are recommended not to configure physical-link-state change suppression time on a port
accessing an RRPP ring to accelerate topology convergence. For details, refer to Ethernet Port
Configuration in the Access Volume .
Configuring RRPP Nodes
z
The maximum number of rings that can be configured on a device in all RRPP domains is 16.
z
If a device carries multiple RRPP rings in an RRPP domain, only one ring can be configured as the
primary ring on the device and the role of the device on a subring can only be an edge node or an
assistant-edge node.
Specifying a master node
Perform this configuration on a device to be configured as a master node.
Follow these steps to specify a master node:
To do… Use the command… Remarks
Enter system view system-view —
Enter RRPP domain view rrpp domain domain-id —
Specify the current device as
the master node of the ring, and
specify the primary port and the
secondary port
ring ring-id node-mode master
[ primary-port interface-type
interface-number ] [ secondary-port
interface-type interface-number ] level
level-value
Required
Specifying a transit node
Perform this configuration on a device to be configured as a transit node.
Follow these steps to specify a transit node: